Table of Contents
Advertisement
KX-TCD725EM-5(86~100)
Before Requesting Help
Problem
While programming or searching, the unit
starts to ring and stops the program/search.
The unit does not display the caller's
phone numbers.
The display goes to the standby mode while
viewing the Caller List or phonebook.
does not function.
The paged handset does not answer.
While using the intercom, two tones sound.
The unit misdials when connected to a PBX.
You cannot register the handset in the
base unit.
When redialling with pressing
, you cannot talk to the other party.
92
01.7.19 10:22 PM
Page 92
To answer the call, press
beginning after hanging up.
Other telephone equipment may be interfering with
your telephone. Disconnect it. Try again.
Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
Do not pause for over 60 seconds while searching.
The handset is too far from the base unit.
The handset is engaged in an outside call or is
viewing the Caller List.
The handset is not in the same radio area.
The handset is engaged in an outside call.
The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 80).
A call is being received. To answer, press
Check the pause function (p. 36).
The base unit has registered a maximum of
6 handsets or the handset has registered a maximum
of 4 base units.
There is interference from other electrical units.
Locate the handset and base unit away from them.
You must finish registration within 1 minute after the
confirmation tone sounds, or programming will be
cancelled (p. 80).
and
Press
Remedy
. Start again from the
.
.
then
Advertisement
Table of Contents
