Ringer Mode Selection - Panasonic KX-TCD725EM Operating Instructions Manual

KX-TCD725EM-3(38~64) 01.7.19 10:42 PM

Ringer Mode Selection

You can select one of 3 base unit ringer modes.
—All handsets: All handsets registered in the base unit ring at the same time.
—Selected handset(s): The only selected handset(s) ring(s) at the same time.
—Selected then all handsets: The selected handset(s) ring(s) first, then if no answer, all handsets start
ringing.
The factory preset is All handsets.
Selecting the All Handsets Ringer Mode
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1
Press .
2
Press or
to "Setting Base", then press
"Input Command" is displayed.
3
1
Press , then enter the 4-digit base
unit PIN (p. 55).
The current mode is displayed.
Selecting the Selected Handset(s) Ringer Mode
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1
Follow steps 1 to 3 on Selecting the All
Handsets Ringer Mode.
2
Press 2 , then select handset
number(s) you desire to ring.
The selected handset number(s) blink(s).
Ex. All registered handset number (1 to 6)
is displayed and selected handset
numbers (1 and 5) blink.
I n p u t C o m m a n d
12 1 2 - 1 2 3 4 5 6
56
Page 56
4
5
until the arrow points
.
3
1
Press .
Press .
A beep sounds.
The display will return to "Setting
Base". To return to the standby mode,
press .
Press .
A beep sounds.
The display will return to "Setting
Base". To return to the standby mode,
press .