KX-TCD735EM(E)-4(76~100)
Monitoring Incoming Calls
While a call is being recorded, you can monitor it through the speaker.
To answer the call, press
Recording a Greeting/Memo Message
You can record a personal message in memory.
To record your own greeting
message
1
Press and hold
A beep sounds.
2
After the beep, talk clearly, about 20 cm
away from the MIC.
The base unit display shows the elapsed
recording time.
3
When finished, press
A beep sounds.
To playback a greeting message
Press
.
One of two pre-recorded greeting messages or your own greeting message is played.
To stop operation, press
To erase your own greeting message
During playback your own greeting message, press
Playback Recorded Messages
You can see the total number of recorded messages on the base unit display.
If Answer ON indicator (
new messages have been recorded. All messages (greeting, incoming, and memo) are stored
indefinitely on a "Flash memory" IC chip – even if a power failure occurs. All of the messages are
saved until you erase them – Flash Memory Message Backup.
<Standby mode on the base unit>
4 m e s s a g e s
0 N e w C a l l s
1 2 . 0 5 1 3 : 5 8
01.10.22 16:16
Page 87
.The unit stops recording.
To record a memo message
1
Press
.
A beep sounds.
2
After the beep, talk clearly, about 20 cm
away from the MIC.
The base unit display shows the elapsed
recording time.
3
When finished, press
.
A beep sounds.
Incoming messages and memo messages
are stored in chronological order.
.
) and the number of recorded message on the base unit display flash,
The unit received 4 messages.
Ex.
.
.
.
87