Panasonic KX-TA1232 User Manual page 4

Location of Controls
TALK/SP-PHONE (Speakerphone) Key:
1
Used to make or answer calls, or
toggle between the two conversation
modes (Receiver/Hands-free*) during
a conversation.
* You can talk with the other party
alternately through the speaker
without holding the handset.
HOLD Key:
2
Used to place a call on Hold.
Meeting Mode Key:
3
Used to turn Meeting Mode on or off
when pressed for more than two
seconds in standby mode.
RECALL/FLASH Key:
4
Used to disconnect the current call
and make another call without hanging
up, or answer a Call Waiting from the
telephone company.
Left/Right Soft Key:
5
Used to select the function displayed
directly above each key. Functions
displayed depend on the state of use.
POWER/CANCEL Key:
6
Used to end calls, exit the Phonebook
or Function mode, or turn the handset
on or off.
Joystick:
7
Used to adjust the ringer/receiver
volume, select the Function mode and
the function displayed directly above it,
and move the cursor to select a
desired item.
TRANSFER/CLEAR Key:
8
Used to transfer a call to another party,
or clear digits or characters.
INTERCOM Key:
9
Used to make or answer intercom calls.
4
Key Lock
You can lock all keys other than the
Joystick while the handset is in standby
mode.
Press the Joystick
for more than
2 seconds to
lock/unlock.
Meeting Mode
You can set the handset to prevent
incoming calls from ringing. This can be
useful in situations where you do not
want to be disturbed, for example during
a meeting.
• During Meeting Mode, functions are:
Function
Microphone volume
Low battery alarm
Key tone
Ringer/Voice Call/Paging/LCS
Ring On Charger
Vibrate
• During Meeting Mode or when Vibrate is set
to Vib.& Ring and Vib.
handset is on charger:
Function
Vibrate*
Ringer
* Please note that, if you set the handset
on the charger while receiving an
incoming call, vibration will stop. Once the
vibration stops, the handset will not
vibrate again for that call, even if the
handset is lifted up again. (If Quick
Answer is set, lifting up the handset will
answer the call.)
<Displayed Icon>
Locked
Unlocked
Status
Up
Off
Off
Off
Off
On
Ring, while
Status
Off
User Setting