Panasonic KX-TA1232 User Manual page 34

Setting the Handset and Base Unit
Main Item
PBX Type
Fwd/DND Icon
Caller ID Line
"PBX Type-Type 1
(KX-TA1232)" only
Date&Time
"PBX Type-Type 2
(KX-TD series)" only
Incoming Log
"PBX Type-Type 2
(KX-TD series)" only
1
* After you set the PBX type, disconnect and reconnect the telephone cord.
2
* To check the type of PBX you are using, see page 30.
3
* When a check mark is displayed beside a tone type, the incoming call log for that tone type
will be logged.
• These settings are only applied to your telephone, not the PBX itself.
34
Description
Selects the type of PBX that
the base unit is connected to.*
When using a PBX other than
a KX-TAW848/KX-TDA series
PBX, you do not need to
change this setting.
Selects which line of information
is displayed as Caller ID. When
the Caller ID matches an item
stored in the Phonebook, the
handset rings according to the
setting of the item. As shown
below, a caller's number, caller's
name and CO line number are
displayed on each line.
Displayed items vary depending
on your PBX and its settings.
<Example>
1st Line
CO01:
2nd Line 01234567890
T.Edison
3rd Line
Sets the current date and time
for the base unit.
Sets each type of Incoming
Call Log to either on or off.*
You must set at least one of the
incoming call types to on to
store a received call in the
Incoming Call Log.
Setting
2
Type 1*
1
Type 2
Mode 1
Mode 2
1st Line
2nd Line
3rd Line
Date
Time
Single Tone
3
On
Off
Double Tone
On
Off
Triple Tone
On
Off
Default
Type 1
Mode 1
1st Line
01-01-05 (D-M-Y)
12:00 AM (H:M)
Single Tone: Off
Double Tone: Off
Triple Tone: Off