Panasonic KX-TA1232 User Manual page 36

Troubleshooting and Error Messages
Problem
Some received calls are not
stored in the Incoming Call Log.
(KX-TD series only)
Some dialed calls are not stored
in the Outgoing Call Log.
Even when in standby mode, you
cannot access the Phonebook or
other menus.
( is displayed in standby
mode.)
Noise is frequently heard.
Two short beeps are heard
during a conversation.
The charge indicator flashes red
rapidly.
You charged the battery for 7
hours, but the beep tones sound
every 5 seconds and
to be charged) flashes after a few
telephone calls.
The battery indicator does not
display the remaining charge
properly after you replace the
battery.
While operating the unit, the AC
adaptor feels warm. While
charging the battery, the handset
feels warm.
36
→ Incoming calls via Voice Call/Paging/LCS/Auto Answer
cannot be stored in the Incoming Call Log.
→ Set at least one of the incoming call types to On. (See
page 34.)
→ Outgoing calls using some PBX features (e.g., Redial, One-
touch Dialing or Speed Dialing) cannot be stored in the
Outgoing Call Log.
• The BGM setting may be on.
→ Press "1" to turn BGM off.
→ Set the handset and base unit away from other electrical
appliances.
→ Move closer to the base unit.
• The radio signal is weak.
→ Move closer to the base unit.
• The charger is not connected properly.
→ Make sure the battery is inserted properly.
→ Set the handset in the charger properly.
• The battery charge contacts may be dirty.
→ Clean the battery charge contacts without damaging them
and charge once more.
(needs
• It is time to change the battery.
→ Replace with a new one.
→ Charge the battery for about 7 hours when the low battery
warning is displayed.
• These are normal conditions.
Description and Solution