Troubleshooting And Error Messages; Troubleshooting - Panasonic KX-TA1232 User Manual

Troubleshooting and Error Messages

Troubleshooting

Problem
The handset does not work.
The handset does not ring.
You cannot make/receive a call.
You cannot dial.
You cannot use the handset
during a power failure.
The headset does not work.
The tone from the headset
cannot be changed to a bell or
melody.
The date and time are not
displayed correctly when viewing
the Incoming Call Log.
While Caller ID is displayed using
the Incoming Call Log, the
display goes blank after pressing
. (KX-TA1232 only)
Troubleshooting and Error Messages
• The battery is drained.
→ Charge the battery fully. (See "Charging the Battery" in the
Installation Instructions.)
• The power is OFF.
→ Turn it ON. (See "Handset" on page 3.)
→ Re-insert the battery and try again. (See "Battery
Installation" in the Installation Instructions.)
• Ringer volume is set to "Off".
→ Adjust the ringer volume level. (See "Adjusting the Ringer
Volume" on page 8.)
• The handset is out of range or the telephone line is not
connected properly.
→ Move closer to the base unit.
→ Check the telephone line.
• The number which you dialed is restricted by the PBX.
→ Consult your dealer.
• The key lock mode is ON.
→ To cancel the mode, press the Joystick for about 2 seconds.
(See "Key Lock" on page 4.)
• The handset will not function during a power failure
because the base unit stops emitting radiowaves.
• A headset tone cannot be heard when receiving an
incoming call, when the headset is attached.
→ Make sure the headset tone setting is set to on. (See
page 31.)
→ Make sure the headset jack is connected properly. (See
"Handset" on page 3.)
• The headset tone is a specific tone and is not related to
the Incoming Option Tone settings (Single/Double/Triple/
S-Double/Private Ring).
→ Only for "PBX Type-Type 2 (KX-TD series)": Set the
correct date and time on the base unit. The form of the date
and time can be set on the handset. (See "Setting the Date
and Time" on page 6.) (See page 34.)
→ Only for "PBX Type-Type 1 (KX-TA1232)": Time settings
can only be changed on the PBX.
• While Caller ID is displayed, the display does not return to
the standby display automatically. If you press
that time, the display goes blank.
→ Press
Description and Solution
then press to return to the standby display.
during
35