Using The Timers - Panasonic SC-VK62D Operating Instructions Manual

VOLUME
DOWN, UP
REC
AUX
, STOP
DISP MODE
TV
CLOCK/
TIMER,
SLEEP
1, 2
TUNER/AUX
, REW/ ,
, /FF
SHIFT
MUTING

Using the timers

The play/record timer
You can set the timer to come on at a certain time to wake you up
(play timer) or to record a radio station or from the aux source
(record timer).
The play and record timers cannot be used together.
Preparation:
•
Turn the unit on and set the clock (A page 6).
•
For the play timer, prepare the desired music source (tape/disc/
radio/aux), and set the volume.
•
For the record timer, check the cassette's erasure prevention
tabs (A page 21) and insert the tape in deck 2 (A page 21).
Tune to the radio station (A page 20) or select the aux source
(A page 25).
1
Press [CLOCK/TIMER] to select the timer function.
Every time you press the button:
CLOCK PLAY
Previous display
rPLAY: to set the play timer
rREC: to set the record timer
(Proceed to the next step within 7 seconds)
1
2
ON time setting
g , REW/4 4 4 4 4 ] or [f g g
g
Press [g
RQT8092
2
time.
24
Press [CLOCK/TIMER].
1
OFF time setting
24
Repeat steps
Headphones
(not included)
DIMMER
AUTO OFF
1 2 3
4 5 6
7 8 9
0 10
TV CH
TV CH
ENTER
TV/AV
, +,
TV VOL
REC
f f f , 3 3 3 3 3 /FF] to set the start
f
2
and .
Using the timers
The play/record timer
3
Press [r r r r r PLAY/REC] to display the timer indicator.
Every time you press the button:
PLAY
rPLAY: to turn the play timer on
rREC: to turn the record timer on
(The indicator doesn't appear if the start and finish times or the
clock hasn't been set.)
4
Press [f f f f f ] to turn the unit off.
PHONES
The unit must be off for the timers to operate.
•
Play timer:
•
Record timer: The unit comes on 30 seconds before the set
To cancel the timer
PLAY/
Press [rPLAY/REC] to clear the timer indicator from the display.
REC,
(The timer comes on at the set time everyday if the timer is on.)
To change the settings (when the unit is on)
To change the play/record times
Do steps 1, 2 and 4.
To change the source or volume
1. Press [rPLAY/REC] to clear the timer indicator from the display.
2. Make changes to the source or volume.
3. Do steps 3 to 4.
To check the settings
Press [CLOCK/TIMER] while the unit is on to select "rPLAY" or
"rREC".
The settings are shown in the following order:
Play timer: start time→finish time→source→volume
,
Record timer: start time→finish time→source
,
To check the settings while the unit is off, press [CLOCK/TIMER]
twice.
If you use the unit after the timers are set
After using, check that the correct tape/disc(s) are loaded before
turning the unit off.
Note
•
If you turn the unit off and on again while a timer is functioning, the
finish time setting will not be activated.
•
If you selected AUX as the source, when the timer comes on, the
unit turns on and engages "AUX" as the source. If you want to
playback or record from a connected unit, set that unit's timer to
the same time. (See the connected unit's instruction manual.)
The sleep timer
This timer turns the unit off after a set time.
While enjoying the desired source:
Press [SHIFT] + [SLEEP] to select the time (minutes).
Every time you press the button:
SLEEP 30
To cancel the sleep timer
Press [SHIFT+[SLEEP] to select "SLEEP OFF".
To confirm the remaining time
Press [SHIFT]+[SLEEP] once.
The remaining time is shown for about 5 seconds.
To change the setting
Press [SHIFT]+[SLEEP] to select the new setting.
You can use the sleep timer in combination with the play/record
timer.
Make sure the unit is off before the play/record timer's start time.
Note
The sleep timer will be turned off when you start recording.
REC
(off)
Play will start in the set condition at the set
time with volume increasing gradually to the
set level.
time with the volume muted.
SLEEP 60 SLEEP 90 SLEEP 120 SLEEP OFF