Switching the appliance on/off and
sound source selection
The appliance is switched on by you selecting a
sound source with the function switch:
Slide the function switch to the position of your
desired sound source.
To switch the appliance off, slide the function
switch to the position "OFF".
Adjusting the volume.
You can adjust the sound volume with the volume re-
• To increase the sound volume turn the volume re-
• To reduce the sound volume turn the volume re-
You can connect headphones to the CD-Player with
Radio with a 3,5 mm Stereo jackplug. The head-
phone connector is to be found at the rear of the
CD-Player with Radio. When you have connected
the headphones, the loudspeakers are disconnected
and you will only hear sound via the headphones.
• Insert the headphone jackplug into the headpho-
Before putting on a set of headphones
turn the volume level down to the mini-
mum! Your hearing could be damaged if
it is subjected to high volume levels for too
long or suddenly!
Raise the telescopic antenna and extend it to full
length. Adjust the antenna positioning so that ra-
dio reception is optimal.
For receiving MW (AM) transmissions, there is an
inbuilt reception antenna. In radio operation, turn
the whole appliance to a position where the best ra-
dio reception is obtained.
Adjust the receptionrange (
the waveband selector. With the adjustment
radio programmes transmitted in stereo will
be played back in stereo. Should the program-
me be received in stereo at full strength the FM
stereo display lights up.
Should the stereo signal in the reception range
be too weak, you can improve it in that
you select the adjustment
the sound is played in Mono.
Through turning the tuning regulator, the desired
radio station can be selected.
- 5 -
. In this adjustment