Troubleshooting - Bifinett KH 670 Operating Instructions Manual

KH670_EU 09.10.2006
bifinett KH 670

Troubleshooting

Problem
The display „Content level - Ice cube
collector container"
The display „Content level - Water
reservoir" glows.
The displays „Content level - Ice cube
collector container"
„Content level - Water reservoir"
are flashing.
The ice cubes are too big and stick
to each other.
The ice cube production process
runs normally, but no ice cubes
are produced.
The control lamp ON/OFF
even though you have just recently
started a production process.
8:33 Uhr Seite 14
Possible Cause
• There are too many ice cubes in the
ice cube collection container
glows. • The temperature of the water is
too low.
• There is too little water in
the water reservoir
and • The throw-out mechanism
cannot move itself.
• The ice cube production
process takes too long.
• The water temperature in the
water reservoir is too low.
• The ambient temperature or
the water temperature in the
water reservoir is too high.
• The cooling system is leaky.
• The pipeline in the cooling
system is blocked.
The power supply to the appliance
flashes,
is unintentionally interrupted during
the ice cube production process.
• Empty the ice cube collection
. container
• Raise the water temperature to
above 7˚C.
• Switch the appliance off, top
up the water level, and after
.
3 minutes switch the appliance
back on.
• Disconnect the power plug.
Check to see if an ice cube
is blocking the throw-out
mechanism. If yes, carefully
remove the ice cube. Restart
the freezing process.
• Contact the Service department
if the throw-out mechanism
continues to be immobile after
removing the ice cube.
• Select a smaller ice cube size.
• Switch the appliance off, wait
until the ice cubes melt, then
switch the appliance back on.
• Exchange the water in the water
reservoir
ture must lie between 7˚C and
32˚C.
• Operate the Ice Cube Machine
with an ambient temperature
of less than 32˚C.
• Fill the water reservoir
colder water.
• Contact the Service department.
Switch the appliance off and remove
the power plug. Wait a few minutes
and remove the possibly jammed ice
cube. Switch the appliance back on
and restart the ice cube production
process.
- 14 -
Solution
.
. The water tempera-
with