Download Print this page

Tools Needed For Installation; Parts Supplied - KitchenAid KEWD175HBL0 Installation Instructions Manual

27" and 30" electric warming oven

Advertisement

Before you start...
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
1_
This is the safety alert
symbol.This symbol alerts
you to hazards that can kill
or hurt you and others. All safety
messages will be preceded by the
safety alert symbol and the word
"DANGER" or "WARNING". These
words mean:
You will be killed or seriously
injured if you don't follow
instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will identify the
hazard, tell you how to reduce the
chance of injury, and tell you what
can happen if the instructions are
not followed.
[mportant:
Observe
aH governing
codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this
oven.
Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.
Cabinet opening dimensions
that are
shown must be used. Given dimensions
provide minimum clearance.
Recessed installation
area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See
"Electrical requirements."
Etectrica_ supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If
the electrical outlet is located in an
adjacent cabinet, provide a 1o3/8" dia.
minimum power supply cord plug
clearance hole in the back of the cutout or
support surface.
Oven support surface MUST be solid,
level and flush with bottom of cabinet
cutout.
There is no provision to level the oven
after it has been installed, if the
installation
is not level, the door may
slide open or not seal tightly allowing
heat to escape resulting in poor oven
performance.
mtis the customer's
responsibility:
To contact a qualified electrical
installer.
To assure that the electrical
installation is
adequate and in conformance
with
National Electrical
Code, AN$I/NFPA 70
E latest edition*, and all local codes and
ordinances.
Copies
of the standards
_isted may be obtained
from:
* Nationa_
Fire Protection
Association
One Batterymarch
Park
Quincy,
Massachusetts
02269
Toolsneededfor installation:
Partssupplied:
PNHips
screwdriver
/

Advertisement

loading

This manual is also suitable for:

Kewd175hbt0Kewd175hss0Kewd175hwh0Kewd105hbt0Kewd105hbl0Kewd105hwh0 ... Show all