Battery Installation - VTech S6120-2 User Manual

Getting started

Battery installation

Install the battery as shown below.
1. Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
color-coded label.
3. Align the cover flat against the battery
compartment, then slide it towards
the center of the handset until it clicks
into place.
• If the handset will not be used for a long time, disconnect and remove the battery
to prevent possible leakage.
• To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
IMPORTANT:
Check for a dial tone by pressing
is successful.
If you do not hear a dial tone:
• Make sure the installation procedures described above are properly done.
• It may be a wiring problem. If you have changed your telephone service to digital
service from a cable company or a VoIP service provider, the telephone line may
need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
2. Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
4. Charge the handset by placing it in
the telephone base or charger.
. If you hear a dial tone, the installation
4