Related Manuals for Stewart Audio AV-50
Summary of Contents for Stewart Audio AV-50
- Page 1 AV Series AV-50-2 AV-50-2 AV Series Power Power Clip Clip AV-50 Owner’s Manual February 2010 www.stewartaudio.com...
-
Page 2: Important Safety Instructions
Airflow through the ventilation openings should be Before using your Stewart Audio Inc. Power Amplifier, please read this unobstructed. Owner’s Manual carefully to ensure optimum trouble-free perform- ance. -
Page 3: Table Of Contents
2.2.2 Rack-Mount Installation ·········································· 6 1.1 Features 2.2.3 Product Dimensions ··············································· 6 Your Stewart Audio AV Series amplifier is the result of years of experi- 2.3 Proper Cooling Considerations ············································ 7 ence in the design and manufacture of quality amplifiers. As such it 2.4 Input Connections ·······························································... -
Page 4: Setup
Clip Clip 2.2.1 Pole-Mount Installation The AV 50 amplifier is the first amplifier in the Stewart Audio family of amplifiers to have the option of pole-mounting. This provides a secure and convenient way to provide quality sound reinforcement for other pole-mounted equipment including video projectors. -
Page 5: Proper Cooling Considerations
2.5 Output Connections Because the AV 50 regulates its temperature using convection cooling Stewart Audio recommends using high-quality, heavy-gauge speaker and no fans, the amplifier must be given adequate space to allow for wire and connectors to send the output signal of your amplifier to the proper airflow. -
Page 6: Output Connections
2.6.1 Dual-Mode Operation (cont.) 2.6.2 Single-Mode Operation Slide the rear-panel switch marked Bridge/Mono/Stereo to the Stereo Your Stewart AV-Series amplifier may also be configured for Mono position. Be sure the power button is off (out), then plug the line cord Operation. -
Page 7: Bridge-Mono Operation
2.6.3 Bridge-Mono Operation Bridge-Mono Wiring Setup Your Stewart AV-Series amplifier has the option to run as a dual-mode Input Stage (stereo) channel amplifier as well as a more powerful single (mono) *Note: Only the right channel (tip) will be used channel amplifier. -
Page 8: Operation
The rear panel contains two input sensitivity knobs as well as a mode switch. The amplifier is set to run off of a line-level source and the sen- NOTE: Stewart Audio will not be held responsible for dam- sitivity should be adjusted for optimum performance. To adjust this age to your AV 50 or connected equipment if the instruc- knob, you will need a small flat-head screwdriver. -
Page 9: Troubleshooting
If after reading this troubleshooting section you are unable to restore Width 8.5in (21.6cm) proper function, return it to your Authorized Dealer for service. Refer to Depth 7.0in (17.8cm) section 6 for instructions. Weight 2.8lbs (1.6kg) Stewart Audio reserves the rate to change features and specifications without notice. -
Page 10: Warranty Information
3-year limited warranty on parts and labor from the data of purchase. In order to be eligible for warranty repairs, If Stewart Audio is unable to contact the sender in 14 days, the mer- the amplifiers and accessories must have been purchased through an chandise will be considered scrap and may be disposed of. -
Page 11: Packaging Instructions
6.2.3 Packaging Instructions (cont.) Stewart Audio Product Line 1. Please write the RA number on three sides of the box. Include the Stewart Audio RA number inside the box and a brief description of Sub-Compact Products the problem. 2. Do not ship any accessories (manuals, cords, hardware, etc.) with...
Need help?
Do you have a question about the AV-50 and is the answer not in the manual?
Questions and answers