Safety Instructions For Installation; Safety Instructions For Connecting Electricity - Kenmore 796.8885 Series Use & Care Manual And Installation Instructions

SAFETY INSTRUCTIONS FOR INSTALLATION

Exhaust/Ducting:
• Gas dryers MUST be exhausted to the outside.
Failure to follow these instructions can result in fire
or death.
• The dryer exhaust system must be exhausted to the
outside of the dwelling. If the dryer is not exhausted
outdoors, some fine lint and large amounts of
moisture will be expelled into the laundry area. An
accumulation of lint in any area of the home can create
a health and fire hazard.
• Use only rigid metal or flexible metal 4-in. diameter
ductwork inside the dryer cabinet or for exhausting
to the outside. Use of plastic or other combustible
ductwork can cause a fire. Punctured ductwork can
cause a fire if it collapses or becomes otherwise
restricted in use or during installation.
• Ductwork is not provided with the dryer, and you
should obtain the necessary ductwork locally. The
end cap should have hinged dampers to prevent
backdraft when the dryer is not in use. Failure to
follow these instructions can result in fire or death.
SAFETY INSTRUCTIONS FOR CONNECTING
ELECTRICITY
To reduce the risk of fire, electric shock, or injury to
persons when using this appliance, follow basic
precautions, including the following:
• Do not, under any circumstances, cut or remove the
ground prong from the power cord. To prevent personal
injury or damage to the dryer, the electrical power cord must
be plugged into a properly grounded outlet.
• For personal safety, this dryer must be properly
grounded. Failure to do so can result in electrical shock
or injury.
• Refer to the installation instructions in this manual for
specific electrical requirements for your model. Failure
to follow these instructions can create an electrical shock
hazard and/or a fire hazard.
• This dryer must be plugged into a properly grounded
outlet. Electrical shock can result if the dryer is not
properly grounded. Have the wall outlet and circuit
checked by a qualified electrician to make sure the
outlet is properly grounded. Failure to follow these
instructions can create an electrical shock hazard and/or a
fire hazard.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
WARNING
• The exhaust duct must be 4-in. (10 cm) in diameter
with no obstructions. The exhaust duct should be
kept as short as possible. Make sure to clean any
old ducts before installing your new dryer. Failure to
follow these instructions can result in fire or death.
• Rigid or semi-rigid metal ducting is recommended
for use between the dryer and the wall. In special
installations when it is impossible to make a
connection with the above recommendations, a UL-
listed flexible metal transition duct may be used
between the dryer and wall connection only. The use
of this ducting will affect drying time. Failure to follow
these instructions can result in fire or death.
• DO NOT use sheet metal screws or other fasteners
which extend into the duct; they can catch lint and
reduce the efficiency of the exhaust system. Secure
all joints with duct tape. For complete details, follow the
Installation Instructions. Failure to follow these
instructions can result in fire or death.
• The dryer should always be plugged into its own
individual electrical outlet which has a voltage rating
that matches the rating plate. This provides the best
performance and also prevents overloading house wiring
circuits which could cause a fire hazard from overheated
wires.
• Never unplug your dryer by pulling on the power cord.
Always grip plug firmly and pull straight out from the
outlet. The power cord can be damaged, resulting in a risk
of fire and electrical shock.
• Immediate repair or replace all power cords that have
become frayed or otherwise damaged. Do not use a
cord that shows cracks or abrasion damage along its
length or at either end. A damaged power cord can melt,
creating an electrical shock and/or a fire hazard.
• When installing or moving the dryer, be careful not to
pinch, crush, or damage the power cord. This will prevent
injury and prevent damage to the dryer from fire and
electrical shock.
5