Specifying Information About Your System - Meridian DSP8000 User Manual

CONFIGURING THE
DSP8000
LOUDSPEAKERS
Option
Position and master/slave
Communications mode (500 or 200)
Controller mode (Auto, Con, or NCon)
System address (1–8)
Product address (1–8)
Volume mode (1=normal,
2/3=second/additional room)
Balance control? (N or Y)
Centre menus? (N or Y)
Diagnostic displays? (N or Y)
Specifying information about your
system
You can configure the operation of the DSP8000 loudspeakers to suit the
way your system is set up, and the way in which you want to use it.
These settings are configured automatically to appropriate values when
you choose one of the standard Type settings, and you should not normally
need to alter them; see Choosing standard settings, page 26.
To configure the DSP8000 loudspeaker
• Turn off the DSP loudspeaker, using the power switch on the back panel.
• Turn on the power again while holding down the 0 key on the remote.
The display will show the current setting of the first configuration option.
For example:
• Press > or < to step between the options.
• Press A or V to change the value of the current option.
The table below shows the options you can configure.
Initial Value
L.
500
Auto
S.A.
P.A.
L.E.
Bal.
Centre N
Diag.
28
L.
1
1
1
Y
N