Advertisement
.
To
1.
Locate handle trim in literature
pack and
install over top and bottom of handle, as
illustrated.
, Secure top handle trim with remaining
screw removed in step 1.
Snap bottom trim over bottom portion
of handle.
Remove:
Remove top handle trim by removing top
handle screw.
Retain trim and screw for later
replacement.
2. Pry bottom handle trim from handle with
_t
screwdriver
flat blade wrapped
in
masking tape.
Retain trim for later replacement.
3. Remove two hex head screws.
Retain screws for later replacement.
Side Mount
Handle
Materials
Needed:
Phillips screwdriver
To Unstall:
1. Remove screws from the side of the
door.
2. Align the side mount handle with the
predrflled
holes in the door panel.
3. Insert the screws in the sequence as
shown.
Freezer
Nandles
Partiam_Width
Nandme
Materiams
Needed:
, Phillips screwdriver
To UnstaH:
1. Install handle by fastening
with
screws removed from edge of door.
If reversing freezer door, remove
door plugs from top edge of door
and insert into screw holes.
To Remove:
1. Remove handle screws with Phillips
screwdriver
and retain screws for
later use.
Front Mount
Freezer
Nandle
Materiams
Needed:
Gloves to protect hands.
Phillips screwdriver.
Plastic handle removal card (or h2" thick plastic
card).
Retain the card.
, There is a slight curve to
this style of freezer
handle.
" For proper installation,
be
sure handle is oriented as shown.
Upper
Handle
....
Lower
,andre i
4. Ensure the door handle is snug to the
door panel.
To Remove:
Reverse installation
procedure.
To UnstaH:
1. Align door handle clips slightly to the left of the
tabs attached to the freezer door.
2. Rotate the handle so the left base is flat against
the door.
Handle
Door
Advertisement
