How To Dismantle Parts - LG SXS Refrigerator Owner's Manual

How to dismantle parts

NOTE
Dismantling is done in the reverse sequence of assembly.
•
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
Freezer
Separate the lamp by pulling it out (➂) while
compartment slightly striking (➀) and rotating (➁) the lamp
cover.
lamp
Turn the bulb counterclockwise. Max. 40 W bulb
for refrigerator is used and can be purchased at
a service center.
NOTE
Not all bulbs will fit your refrigerator.
•
Be sure to replace the bulb will one of the same size, shape and wattage.
The dispenser lights are LEDs that can not be changed.
•
Freezer
To remove a shelf, lift the left part of the shelf
compartment
a bit, push it to the direction ( ), lift the right
shelf part to the direction ( ), and take it out.
Door rack and
Lift the door rack holding both sides ( ) and
pull it out to ( ) direction.
support
Space plus
Lift the space plus ( ) and pull it out to ( )
direction.
Hold the ice storage bin as shown in the right
Ice storage bin
figure and pull it out ( ) while slightly lifting it
( ).
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Be sure to use both hands when removing
the ice storage bin, so as not to drop it on the
floor.
If the ice storage bin does not fit well, slightly
rotate the rotating device.
After dispenser
The water collector has no self-drainage
is used function. So it should be cleaned regularly.
Remove the cover by pulling the front of the
water collector cover and dry it with a cloth.