Table of Contents
Advertisement
Care and maintenance
Freezer
compartment
lamp
Freezer
compartment
shelf
Door rack and
support
Ice storage bin
After dispenser
is used
53
How to dismantle parts
NOTE
Dismantling is done in the reverse sequence of assembly.
•
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
Separate the lamp by pulling it out ➂ while slightly
pressing ➀ and rotating ➁ the lamp cover.
Turn the bulb counterclockwise. Use a 40-watt bulb
(max.) which can be purchased at a service
center.
NOTE
Not all bulbs will fit your refrigerator.
•
Be sure to replace the bulb will one of the same size, shape and wattage.
The dispenser lights are LEDs that can not be changed.
•
To remove a shelf, push the shelf to the left ,
lift the left part of the shelf a bit ➀, lift the right
part up ➂ , and take it out.
Lift the door rack holding both sides
pull it out .
Hold the ice storage bin as shown in the right
figure and pull it out
while slightly lifting it
Do not dismantle the ice storage bin unless
it is necessary.
Use both hands to remove the ice bin to avoid
dropping it.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Pull the cover fully to the front ➀ and pull up
the rear end of the cover ➁ slightly to pull it out.
➂ Clean the floor and cover with a dry cloth.
!
and
.
!
2
1
!
Advertisement
Table of Contents
