Table of Contents
Advertisement
IN$
LATION
REQUIREMENTS
TOOLS
AND
PARTS
Gather the required tools and parts before starting installation.
Tools
needed:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
#2 Phillips screwdriver
Tin snips (new vent
installations)
Parts needed:
(Not supplied with dryer)
[] Vent clamps
[] Vent elbows and ductwork
Additional parts may be required, depending
in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
if using
a power
supply
cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
[] A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
[] A UL listed strain relief.
1/4" and 5/16" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied if installing with a
pedestal or a stack kit.
Leveling legs (4)
"Y" connector
Utility knife
Tape measure
Short inlet hose
Long inlet hose
Level
Pliers
Caulking gun and
compound
(for installing
new exhaust vent)
Min. 8" long Torx Ce T25
screwdriver
(for door reversal only)
Rubber washer
Optional
Equipment:
(Not supplied with dryer)
Refer to your Use and Care Guide for information
about
accessories
available for your dryer.
® TORX is a registered trademark of Saturn Fasteners, Inc.
3
Hide quick links:
Advertisement
Table of Contents
