Maytag MED6000AW0 Installation Instructions Manual page 18

Reverse door swing round=shaped door
iMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a Torx ®t T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
2, Move the door strike
®
®
®
®
®
®
®
Using a Torx ®t T25 screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Rotate the
strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
1 ® TORX is a registered trademark of Saturn Fasteners, Inc.
18
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 10 screws securing the inner
door to the outer door. Lift off the inner door and set aside.
Remove outer window assembly
from trim ring
A
Using a Phillips screwdriver, remove the 2 screws from the outer
window retainer and rotate the outer window assembly clockwise
until the square notches line up with the 4 tabs on the trim ring
indicated with arrows in the figure A above. Then lift out the outer
window and retainer up and off the trim ring and set aside (B).