Advertisement
Available languages
Available languages
Cabinet
Dimensions
IMPORTANT: If installing a range hood or microwave hood
combination
above the cooktop, follow the range hood or
microwave hood combination
installation instructions
for
dimensional clearances above the cooktop surface.
A. 23 ½" (60.0 cm)
B. Combustible
area above countertop
(shown by dashed box
above)
C. 30" (76.2 cm) minimum clearance between top of cooktop
platform and bottom of uncovered
wood or metal cabinet
(24" [61.0 cm] minimum clearance if bottom of wood or metal
cabinet is covered by not less than ¼" [0.6 cm] flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" [0.04 cm] stainless steel, or 0.024" [0.06 cm] aluminum
or 0.020" [0.05 cm] copper)
D. 13" (33.0 cm) recommended
upper cabinet depth
E. 2" (5.1 cm)
F. 19¼"+_ _"
(49.0 +_0.16 cm)
G. 18" (45.7 cm) minimum
clearance from upper cabinet to
countertop
within minimum horizontal clearances to cooktop
H. Junction box or outlet: 6" (15.2 cm) minimum
from top of
countertop;
7" (17.8 cm) maximum from right side of cabinet
1.22¼/'+_ ¼J' (56+_0.16cm)
J. 4" (10.0 cm) minimum distance to nearest left and right side
combustible
surface above cooktop
NOTES:
•
After making the countertop cutout, some installations may
require notching down the base cabinet side walls to clear
the cooktop base. To avoid this modification,
use a base
cabinet with sidewalls wider than the cutout.
If cabinet has a drawer, a 41/8"(10.5 cm) depth clearance from
the top of the countertop to the top of the drawer (or other
obstruction)
in base cabinet is required.
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If codes permit and a separate ground wire is used, it is
recommended
that a qualified electrical installer determine that
the ground path and wire gauge are in accordance
with local
codes.
Check with a qualified electrical installer if you are not sure the
cooktop is properly grounded.
Make sure that the electrical connection and wire size are
adequate and in conformance
with the CSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2 No. O-M91-1atest
edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
CSA International
178 Rexdale Boulevard
Toronto, Ontario
Canada M9W 1R3
Before You Make the Electrical
Connection:
To properly install your cooktop, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
•
A 3-wire or 4-wire, single phase, 120/240 volt, 60-Hz., AC
only electrical supply is required on a separate, 40-amp
circuit fused on both sides of the line. The model/serial
number rating plate is located on the metal cabinet
underneath the cooktop. See the following illustration.
'i
A
A. Model/serial
number plate
Advertisement
