The Backlight; The Reset Hole; Default Settings; Troubleshooting Guide - Oregon Scientific RM818P User Manual

NOTE The vibrating device is powered by two "AA"
1.5V alkaline batteries (included). It is also compatible
with rechargeable batteries (not included).

THE BACKLIGHT

The user can press the SNOOZE / LIGHT button at the
base of the unit to enable the backlight function and the
backlight will be turned on and last for 5 seconds.

THE RESET HOLE

If the clock behaves strangely or stops responding, insert
and press a blunt stylus into the clock's Reset Hole. (This
is located on the back of the clock. Simply insert a blunt
stylus to reset the unit's settings).

DEFAULT SETTINGS

All segments of the LCD will be turned on for 3 seconds
and a beep sound will be given out. Then it will start RF
reception.
• The Clock Setting are: PM12:00, 1st January,
2004, RF enabled, English.
• The Clock and alarm displays in 24 / 12 hour
mode depending on the selection of radio signal
(EU / UK).
• Both the bell alarm and the vibration alarm of
Alarm 1 and Alarm 2 are disabled.
RM818P English R7
• The battery status is displayed.
• The projector is disabled.
NOTE
setting as seen above.

TROUBLESHOOTING GUIDE

BASIC FUNCTIONS

This section includes a list of frequently asked questions
for problems you may encounter. If your device is not
operating as you think it should, check here before
arranging for servicing.
18
18
The clock will then be reset to its original factory
7/14/04, 3:58 PM