Advertisement
Available languages
Available languages
You must have:
•
120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical
supply.
•
Copper wire only.
We recommend:
•
A time-delay fuse or circuit breaker.
•
A separate circuit.
If direct wiring dishwasher:
•
Use flexible, armored or nonmetallic sheathed, copper wire
with grounding wire that meets the wiring requirements for
your home and local codes and ordinances.
•
Use strain relief method provided with house wiring junction
box or install a UL-listed/CSA-certified
clamp connector to
the house wiring junction box. if using conduit, use a
UL-listed/CSA-certified
conduit connector.
If connecting
dishwasher
with a power supply cord:
•
Use Power Supply Cord Kit (Part Number 4317824) marked
for use with dishwashers.
Kit contents include:
•
Voltex, inc., UL listed 16 gauge 3 wire power supply cord
with 3 prong grounded plug.
•
Neer C-5007/o. strain relief.
•
3 wire connectors.
•
Part Number 302797 grommet.
Follow the kit instructions
for installing the power supply
cord.
Power supply cord must plug into a mating three prong,
grounded outlet, located in the cabinet next to the
dishwasher opening. Outlet must meet all local codes and
ordinances.
IMPORTANT: if you plan to install a garbage disposer, an
additional separate 120-volt, 60 Hz, AC-only, 15 or 20 amp fused
electrical supply is required.
•
A hot water line with 20-120 psi (138-862 kPa) water
pressure.
•
120°F (49°C) water temperature at dishwasher.
•
Flexible stainless steel braided fill line (1/2"minimum plastic
tubing is not recommended).
Use the new drain hose supplied with your dishwashen if this
is not long enough, use a new drain hose with maximum
length of 12 ft (3.7 m) that meets all current AHAM/IAPMO
test standards,
is resistant to heat and detergent, and fits the
1" (2.5 cm) drain connector
of the dishwashen
Connect drain hose to waste tee or disposer inlet above drain
trap in house plumbing and 20" (50.8 cm) minimum above the
floor. It is recommended
that the drain hose either be looped
up and securely fastened to the underside of the counter, or
be connected to an air gap.
INSTALLATION
INSTRUCTIONS
Electrical
Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher,
Failure to do so can result in death or electrical shock,
1. Disconnect
power.
2. Turn off water supply.
1. Read valuable information on exterior of shipping box before
opening.
2. Remove shipping materials, tape and film from the
dishwasher. Remove parts package from inside the
dishwasher.
6
Advertisement
