Picture/Sound Settings - Sony FWD-S42H1 Operating Instructions Manual

010COV.book Page 22 Friday, June 27, 2008 7:25 AM

Picture/Sound Settings

For Video Input
VIDEO
Picture Mode
Picture Mode Adjust.
22
GB
To highlight an option and to change settings, press
F
Press
The "Picture/Sound" settings include the following
options:
"Vivid": Select for enhanced picture contrast and sharpness.
"Standard": Select for standard picture settings.
"Custom": Allows you to store preferred settings.
"Conference": Adjusts the picture quality for video conferencing under fluorescent
lights.
"TC Control": The setting is common with "Vivid". In addition, you can use the
"True Color Control" function (after-mentioned).
Tip
To change from one "Picture Mode" option to another, you can also use PICTURE on the
remote control instead.
Notes
• "Conference" may not be effective depending on the environment or the video conference
system under use. In this case, adjust the picture quality, switch to other settings of "Picture
Mode", etc.
• In "TC Control", "Brightness Boost" is fixed to Off.
"Backlight": Adjusts to brighten or darken the screen.
"Contrast": Adjusts picture contrast.
"Brightness": Adjusts to brighten or darken the picture.
"Chroma": Adjusts to increase or decrease color intensity.
"Phase": Adjusts the color tones of the picture.
"Sharpness": Adjusts to sharpen or soften the picture.
"Noise Reduction": Select to reduce the noise level of connected equipment. Select
from "Off", "Low", "Mid", "High" to set the noise level.
"CineMotion": Select "Auto" to optimize the screen display automatically
detecting film content and applying a reverse 3-2 pull down or 2-2 pull down
process. Moving picture will appear clearer and more natural looking. Select "Off"
to disable the detection.
"Dynamic Picture": Select "On" to enhance contrast by making white brighter and
black darker.
"Gamma Correct.": Balances the light and dark portions of pictures. Select from
"High", "Mid", "Low" to make settings.
Notes
• "Option" can only be set when there is a DVI input.
• Gamma setting is in accordance with the Grayscale Standard Display Function (GSDF) of
the Digital Imaging and Communications in Medicine (DICOM) standards. However, this
setting is for reference only and cannot be used for medical diagnosis.
"Color Temp.":White tone can be adjusted to suit your preference. The factory
default settings are adjusted to color temperature.
"Cool": Select to give the white colors a blue tint.
"Neutral": Select to give the white colors a neutral tint.
"Warm": Select to give the white colors a red tint.
"Custom": Enables a broader range of white tone to be set than above.
f G g
/ / / .
to confirm the selection.
FWD-S42H1/FWD-S47H1
4-111-559-01(1)