Internal Clock Battery - Christie LW400 User Manual

Internal clock battery

Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has
stopped, please replace the battery according to the following procedures.
1. Turn the projector off, and unplug the power cord. Allow the
projector to cool suffi ciently.
2. After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.
3. Turn the battery cover in the direction indicated "OPEN"
using such as coins. Then the battery cover will come up.
While removing the battery cover, pick its knob.
4. Press the metal claw of the battery holder. Then the battery
will come up. Remove the battery.
5. Replace battery with HITACHI MAXELL, Part No.CR2032
only.
Put a new battery into battery case. Please make sure that the +
is facing upward. Insert the battery case slowly into the battery
slot until you hear the snap.
Note: If the battery is placed in the battery holder upside-
down,
(1) Remove the battery cover and turn the projector so that top
faces up.
(2) While lifting the side of the projector closest to the lens,
press the metal claw of the battery holder. The battery will
fall out of the holder, so be careful not to lose it.
6. Close the battery cover. Replace the battery cover in place,
then turn it in the direction indicated "CLOSE" using such as
coins, to fi x.
WARNING
►
Always handle the batteries with care and use them only as directed. Battery may explode if
mistreated. Do not recharge, disassemble or dispose of in fi re.
And also improper use may result in cracking or leakage, which could result in fi re, injury and/or
pollution of the surrounding environment.
• Be sure to use only the batteries specifi ed.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets. If swallowed consult a physician immediately for
emergency treatment.
• Do not short circuit or solder a battery.
• Do not allow a battery in a fi re or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace a battery. If the leakage
adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
LW400 User Manual - Concise
020-000051-01 Rev.1 (05/08)
"+" marking
11
Battery Cover
Metal claw
Knob