Uploading The Firmware Via Boot Commands - ZyXEL Communications VOP1372G-61 User Manual

Chapter 3 Troubleshooting
After a successful configuration file upload, type atgo to restart the line card.
4
Bootbase Version: V1.00 | 03/23/2005 16:10:06
FLASH: AMD 32M
Hardware Version:
Serial Number:
RAM: Size = 133120 Kbytes
ZyNOS Version: V3.97(UHE.0) | 05/19/2011 11:56:26
Press any key to enter debug mode within 3 seconds.
...........
Enter Debug Mode
atlc
Starting XMODEM upload (CRC mode)....
CCCC
Total 393216 bytes received.
Erasing...
...........................................................................
.....OK
atgo

3.3.2 Uploading the Firmware via Boot Commands

Usually you should use FTP with the MSC to upload the line card's firmware. If you cannot manage
the line card from the MSC, use the following procedure to upload firmware to the line card.
Obtain the firmware file, unzip it and save it in a folder on your computer.
1
Connect your computer to the console port and use terminal emulation software configured to the
2
following parameters:
• VT100 terminal emulation
• No parity, 8 data bits, 1 stop bit
Pull out the line card and push it back in to restart it and begin a session.
3
When you see the
4
press a key to enter debug mode.
Type
5
atba5
115200 bps).
Change the configuration of your terminal emulation software to use 115200 bps and reconnect to
6
the line card.
Type after the
7 atur
Wait for the
8
terminal.
28
Press any key to enter Debug Mode within 3 seconds
after the
Enter Debug Mode
Enter Debug Mode
Starting XMODEM upload
• 9600 bps
• No flow control
message (this changes the console port speed to
message.
message before activating XMODEM upload on your
,
message
VOP1372G-61 User's Guide