Installing A 3.5-Inch Hard Disk Drive Into The Bracket; Installing A 2.5-Inch Hard Disk Drive Into The Bracket - Lenovo ThinkStation 4157 Hardware Installation And Replacement Manual

To install a new hard disk drive:
1. Remove the computer cover. See "Removing the computer cover" on page 11.
2. Locate one of the empty hard disk drive slots in bay 4. See "Locating internal components" on page 7.
Each empty hard disk drive slot has a spare bracket.
3. Pull the handle to remove a spare bracket.
4. To install the new hard disk drive into the bracket, flex the bracket, and then align pin
3 , and pin 4 on the bracket with the holes in the hard disk drive. Do not touch the circuit board
on the bottom of the hard disk drive.
Figure 16. Installing a 3.5-inch hard disk drive into the bracket
Note: If you are installing a 2.5-inch hard disk drive into the bracket, flex the bracket, and then align pin
1 , pin 2 , pin 3 , and pin
Figure 17. Installing a 2.5-inch hard disk drive into the bracket
5. Install the hard disk drive and bracket into the drive bay.
4 on the bracket with the holes in the hard disk drive adapter
.
Chapter 3 Installing options and replacing hardware
1 , pin 2 , pin
5
5 .
21