Installation Requirements; Tools And Parts - Maytag MHW4200BG1 Installation Instructions Manual

INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open end
wrenches 1/2" (13 mm)
and 9/16" (14 mm)
Level
Wood block
Ruler or measuring tape
Pliers that open to
19A6 ' ' (39.5 mm)
Optional tools:
( 3
Flashlight Bucket
Parts needed: (Not supplied with washer)
Water inlet hoses (2)
Flat inlet hose washers (4)
Parts supplied:
NOTE: All parts supplied for installation are in the washer
basket.
Cable tie
Transport bolt hole
plugs (4)
Drain hose with clamp
and form (may be shipped
unassembled)
Available Accessories:
An optional matching pedestal is available for your washer.
Please contact your retailer for ordering information, or see
the "Assistance or Service" page on the back of your "Use and
Care Guide".
Alternate parts: (Not supplied with washer)
Your installation may require additional parts. To order, please
refer to toll-free numbers on the back page of your "Use and
Care Guide".
If you have:
Overhead sewer
1" (25 mm) standpipe
You will need:
Standard 20 gal. (76 L) 39" (990 mm)
tall drain tub or utility sink, sump
pump and connectors (available from
local plumbing suppliers)
2" (51 mm) diameter to 1" (25 mm)
diameter Standpipe Adapter
Part Number 3363920
Connector Kit Part Number 285835
Drain hose too short Extension Drain Hose Part
Number 285863
Connector Kit Part Number 285835
Lint clogged drain
Drain Protector Part Number 367031
Connector Kit Part Number 285835
Floor drain system Siphon Break Kit Part Number 285834
Connector Kit (x2) Part Number 285835
Extension Drain Hose Part
Number 285863
2