KitchenAid KGRS505XWH02 Installation Instructions Manual page 8

Wall Mounting
A. #12 x 1%" screws
B. Anti-tip bracket
5. Using a Phillips screwdriver, mount anti-tip bracket to the wall
or floor with the two #12 x 1%" screws provided.
Explosion Hazard
Use a new CSA international approved gas supply line.
instal a shut=off valve.
Securely tighten all gas connections.
if connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
3.
Use a _%e"combination wrench and an adjustable wrench to
attach the flexible connector to the adapters. Check that
connector is not kinked.
.............. A
r
2,,: i
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have Y2"male
pipe thread)
D. Flexible connector
E. Manual gas shutoff valve
F Y2" or 3/4"gas pipe
G. Use pipe-joint compound.
H. Adapter
4. Gas supply pipe must be located within the shaded area as
shown in the "Cabinet Dimensions" illustration in "Location
Requirements" section.
A
/
A. Gas pressure regulator
B. Adapter
C. Flexible connector
D. Manual shutoff valve
Typical flexible connection
1. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in the following illustration).
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters.
8