KitchenAid KGRS505XWH02 Installation Instructions Manual page 10

Adjust Flame Height
Adjust the height of top burner flames. The cooktop "LO" burner
flame should be a steady blue flame approximately 1¼. (0.64 cm)
high.
A
A. Low flame
B. High flame
To adjust standard burners:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the "low" flame needs to be adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem in the low position using a pair of pliers.
Use a 1/8"(3.0 ram) flat-blade screwdriver to turn the screw
located in the center of the control knob stem until the flame
is the proper size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
5. Repeat steps 1 - 4 for each burner.
Check Operation of Both Oven Bake Burners
1. Press the BAKE keypad for the desired oven.
"BAKE" scrolls down in the upper text display area or scrolls
up in the lower text display area, depending on oven
selection, and 350°F is displayed. After 3 seconds "Set temp"
scrolls in the selected oven text display area, followed by
"Push START."
2. Press START pad. "Baking" scrolls in the selected oven text
display area. Then, after 3 seconds, "Preheating" scrolls in
the display.
The igniter used to light the bake burner will glow. Once the
igniter is hot, the oven bake burner should light. Under certain
conditions, it may take up to 60 seconds for it to light.
If burners do not light properly:
• Press OFF/CANCEL to turn off the oven.
• Check that the range is plugged in and circuit breaker has not
tripped or the household fuse has not blown.
• Check that the gas shutoff valve is set to the "open" position.
Repeat start-up. If burner does not light, press OFF/CANCEL to
turn off the oven and contact your dealer or authorized service
company for assistance.
Check Operation of Oven Broil Burner
1. Press BROIL for the upper oven. "BROIL" scrolls down in the
upper text display area, and 550°F is displayed. After
3 seconds, "Set temp" scrolls in the upper oven text display
area, followed by "Push START."
2. Press START. "Broiling" scrolls in the upper oven text display
area and remains there until the set temperature is reached.
The igniter used to light the broil burner will glow. Once the
igniter is hot, the oven burner should light. Under certain
conditions, it may take up to 60 seconds for it to light.
If burners do not light properly:
• Press OFF/CANCEL to turn off the oven.
• Check that the range is plugged in and circuit breaker has not
tripped or the household fuse has not blown.
• Check that the gas shutoff valve is set to the "open" position.
Repeat start-up. If burner does not light, press OFF/CANCEL to
turn off the oven and contact your dealer or authorized service
company for assistance.
10