Installation Requirements; Tools And Parts; Gas Supply Requirements; Electrical Requirements - KitchenAid KGRS308BSS1 Installation Instructions Manual

30" (76.2 cm) freestanding gas ranges
Table of Contents

Advertisement

Available languages

Available languages

In the State of Massachusetts,
the following installation instructions apply:
• Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not exceed 3 feet.
Anti-Tip
Bracket
Range Foot
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip
bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged
in the slot of the anti-tip bracket.
Re-engage
anti-tip bracket
if range is moved.
Do not operate range without
anti-tip bracket
installed
and engaged.
Failure to follow these instructions
can result in death or serious
burns to children
and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Parts supplied
Check that all parts are included.
Tools needed
A
Tape measure
Flat-blade screwdriver
Phillips screwdriver
Level
Hand or electric drill
Hammer
Wrench or pliers
Pipe wrench
18/ls"combination
wrench
1¼.drive ratchet
3/8"nut driver
1/8"(3.2 mm) drill bit (for
wood floors)
Marker or pencil
Pipe-joint compound
resistant to LP gas
Noncorrosive
leak-detection
solution
For LP/Natural
Gas
Conversions
3/8"combination
wrench
1/2" combination wrench
8/8"combination
wrench
7 mm (8/32") n ut driver
Quadrex ®t or Phillips
screwdriver
Masking tape
B
!
A. Anti-tip bracket
B. #12 x 1_" screws (2)
Anti-tip bracket must be securely mounted to floor or wall.
Thickness of flooring may require longer screws to anchor
bracket to floor.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements"
and
"Gas Supply Requirements"
sections.
1-@QUADREX
is a registered
trademark of NLW Holdings, Inc.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents