LED is lit up constantly (orange). - Allow the lamp to cool for 1 hour before replacing it. - Replace only with the same type lamp from an LG Electronics Service Center. Using another manufacturers lamp may cause damage to the Projector and lamp.
Replacing the Lamp Replacing the Lamp Turn off the projector and unplug the power cable. Lamp case screw Carefully place on a cushioned surface. (Allow the lamp to cool for 1 hour before removing the used lamp from the projector.) Unscrew the screw from the lamp cover using a screwdriver.
Using another manufacturers lamp may cause damage to the projector or lamp. Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on. If this fault persists contact an LG Authorized Service Center. Reset Lamp Time Reset Lamp Time * You must reset lamp time on the menu after replacing the lamp.