Set Up The Scale's Wi-Fi Connection - iHealth HS5 Owner's Manual

and WPA2 personal security modes.
Install Batteries
Open the battery cover on the back of the Scale and
insert four "AA" batteries.
If "Lo" appears on the LED, replace all the
!
batteries.
Rechargeable batteries are not suitable for this
!
Scale.
To avoid damage as a result of battery leakage,
!
remove the batteries if the Scale is not going to
be used for 3 months or more.
Avoid getting battery fluid in your eyes. If it gets
!
in your eyes, immediately rinse with clean water
and contact a physician.
The Scale and the batteries must be disposed of according to
local regulations at the end of their service life.
Select Weight Unit
Select a weight unit by adjusting
the switch under the battery cover.

SET UP THE SCALE'S WI-FI CONNECTION

(Prior to first use, or when changing routers.)
STEP 1: Connect iOS device to your home Wi-Fi.
(Settings->Wi-Fi->On)
STEP 2: Turn Bluetooth "On" on your iOS device and it will start
searching for the Scale.
STEP 3: Wait until the model name, "iHealth HS5xxxxx" , and "Not
Paired" appear on your device's Bluetooth screen. Select
the model name "iHealth HS5xxxxx" to pair and
connect. (Note: it may take up to 30 seconds for your iOS
device to detect the Bluetooth signal")
4
PUSH
PUSH