Table of Contents
Advertisement
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
G
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
G
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
capability.
G
After new batteries are inserted into the remote controller, the unit will initially require approximately 10
seconds to respond to commands and operate.
˚
CH
˚
CH
RESET
AUTO
HEAT
DEHUMIDIFY
COOL
FAN
FAN SPEED
LOW
MED
HI
SLEEPING
STOP (CANCEL)
START (RESERVE)
START/STOP
TIME
TIMER SET
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
G Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
G Display
This indicates the room temperature selected, current time, timer status, function
and intensity of circulation selected.
G START/STOP button
Press this button to start operation. Press it again to stop operation.
G SLEEP button
Use this button to set the sleep timer.
G TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed, and
the value will change more quickly.)
G TIME button
Use this button to set and check the time and date.
G RESET buttons
G FUNCTION selector
Use this button to select the operating mode. Every time you press it,
the mode will change from
(COOL) and to
G FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from
(during the
(FAN) mode, from
G AUTO SWING button
Controls the angle of the horizontal air deflector.
G TIMER control
Use this button to set the timer.
G OFF-TIMER button
G ON-TIMER button
G RESERVE button
G CANCEL button
Precautions for Use
G
Do not put the remote controller in the following places.
G
Under direct sunlight.
G
In the vicinity of a heater.
G
Handle the remote controller carefully. Do not drop it on the floor,
and protect it from water.
G
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
G
If you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
(AUTO) to
(FAN) cyclically.
(AUTO) to
HI to
Select the turn OFF time.
Select the turn ON time.
Time setting reservation.
Cancel time reservation.
– 6 –
(HEAT) to
(DEHUMIDIFY) to
(HI) to
(MED) to
MED to
LOW).
(LOW)
Hide quick links:
Advertisement
Table of Contents
