Roof Jack Installation; Roof Jack Selection; Application Notes - Nordyne M1B Installation Instructions Manual

SCREWS MOUNTING
DUCT _' :_ PLATE
CONNECTOR i i
CONNECTION
Figure 13. Round Duct Connector Installed
SLIDE FURNACE
ALL THE WAY BACK
ONTO MTG. PLATE
/
//
/
Figure 14. "A" & "B" Cabinet Furnaces
Figure 15. "A" Cabinet Furnace on Coil
Cabinet
"_- ROOF JACK
_ SLANT DECK
FLASHING
PITCHED j
ROOF
f i II"x" (SEE TABLE 5)
CEILING ,_, ,_-- I_
lii'--P'uePip e
--ILIN _ ,_--Combustion Air Pipe
Furnace 66"or
76"
Figure 16. Ceiling Cavity Depth
ROOF JACK iNSTALLATION
Required ceiling and roof cut-out openings (see
Figure 11) must be carefully located to avoid
misalignment of the furnace and Roof Jack.
Note: Install only Roof Jack Assemblies listed
in Table 4 on this heating appliance.
Roof Jack Selection
1. Determine depth of ceiling cavity from center
of roof opening to center of ceiling opening.
(See Dimension "A" in Figure 16.)
2. Determine ceiling height and subtract height
of furnace. (See Dimension "B" in Figure 16.)
3. Add dimensions A + B (and X from Table 5
and Figure 18 if slant deck flashing is used).
The total length of (A + B + X) must be within
the minimum and maximum range of one of
the Roof Jacks listed in Table 4.
Application Notes:
, FAW, FAWT, SAW and SAWT Series Roof
Jacks with a 5" diameter inner vent pipe may
be used with all models of M1 Series gas and
M5 Series oil furnaces.
F = Flat Flashing: flexes from 0/12 to 1/12 roof
slope. See Figure 17 (page 12).
S = Slant Flashing: 2.5/12 Slope flexes from
1/12 to 4/12 roof slope, 4/12 flexes from
3/12 to 5/12. See Figure 18.
o
o
Stainless steel roof jacks are available.
M1/M5 furnaces may be used with roof jacks
as tall as 170" (except M1M 056 & M1B 066
models, which are limited to 120"). An internal
roof jack extension (p/n 901935 - 10", p/n
903107 - 18") can be used to increase roof
jack height. All connections inside the home
must be made below the ceiling.
NOTE: If the roof jack crown is covered or blocked
with snow, the furnace will not operate properly.
MODEL NUMBER
(ES)AW(T)1523-(0,2,4)(A,S)
(ES)AW(T)2135-(0,2,4)(A,S)
(F,S)AW(T)2747-(0,2,4)(A,S)
(F,S)AW(T)3563-(0,2,4)(A,S)
(F,S)AW(T)5195-(0,2,4)(A,S)
S AW T 27
APPROX. LENGTH
BELOW FLASHING
15"-23"
21"- 35"
27"- 47"
35"- 63"
51"- 95"
47 - 2 S
T T U T T T 2F'UESTEELTYPE
F = FLAT FLASHING _ I I I I I A= ALUMINIZED
S=SLANT FLASHING / WIN. ADJ. / S=STAINLESS
LENGTR /
AW= ALL WEATHER
/ /
_ FLASHING
/ / PITCH/12" RISE
/ / 0=FLAT
/ / 2=2,5/12
TYPE: / / 4=4/12
BLANK = NON-TRANSIT _ /
L MAX ADJ
T= TRANSIT MODE " '
LENGTH
Table 4. Roof Jack Assemblies
11