Direct Vent (SeaHed Combustion)
Forced
Air Gas Furnaces
M3RL Series 90+ Downfiow
Condensing
Furnace
For installation in:
I. Manufactured
Homes
2. Park Models and Manufactured
Buildings
3. Modular Homes/Buildings
WARNING:
FiRE OR EXPLOSION
HAZARD
Failure to fol!ow safety warnings
e×actly could
result in serious
injury, death or property
damage.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
-WHAT
TO DO mFYOU SMELL GAS
o Do not try to light any appliance.
o Do not touch any electrical switch; do not use any
phone in your building.
, Leave the building immediately.
o Immediately call your gas supplier from a neighbor s
phone. Follow the gas supplier's instructions.
, If you cannot reach your gas supplier, call the fire
department.
-installation
and service
must be performed
by a
qualified installer, service agency, or the gas sup-
plier.
RISQUE
D'INCENDmE OU D'EXPLOSmON
Le non-respect
des avertissements
de s_curit_
pourrait
entra_ner
des blessutes
graves,
la
mort ou des dommages
mat_rieJs.
- Ne pas entreposer
ni utiliser de I'essence ni
d'autres vapeurs ou liquides inflammables
dans Ic
voisinage de cet appareil, ni de tout autre apparei
-QUE
FAmRE S'IL YA
UNE ODEUR
DE GAZ
o Ne pas tenter d'allumer aucun appareil.
,Ne
toucher
a aucun
interrupteur
61ectdque;
n'utiliser aucun t616phone dans le b_timent.
o E_vacuer I'immeuble immCdiatement.
, Appeler immCdiatement
le foumisseur
de gaz en
employant
le t616phone d'un voisin. Respecter
la lettre les instructions
du foumisseur
de gaz.
o Si personne
ne repond, appeler le service des
incendies.
- Uinstallation
et I'entretien doivent Ctre effectues
par un installateur
qualifie, un organisme de
service ou le fournisseur
de gaz.
BW Models
BWT Models
WARNING:
Shoumd overheating
occur,
or the
gas suppty
fail to shut
off, shut
off the manual
gas valve
to the
appliance
before
shutting
off the
electrical
supply.
Improper
installation,
adjust-
ment,
amteration,
service
or
maintenance
can cause
injury
or property
damage.
Refer
to
this
manual.
For assistance
or
additional
information
consult
a qualified
installer,
service
agency
or the gas supplier.
LEAVE THESE mNSTRUCTmONS WroTHTHE HOMEOWNER.
Need help?
Do you have a question about the M3RL 060A AW and is the answer not in the manual?
Questions and answers
Ignitor comes on but never lights no faults
The ignitor on the Nordyne M3RL 060A AW may come on but never light due to several possible reasons:
1. Gas Supply Issue – The gas valve may not be opening, preventing gas from reaching the burners.
2. Faulty Gas Valve – If the gas valve does not open after the ignitor warms up, ignition cannot occur.
3. Ignitor Malfunction – The ignitor may not be reaching the proper temperature to light the gas.
4. Blocked Burner Orifice – The orifice inside the burner box may be clogged, preventing gas flow.
5. Vent Safety or Limit Switch Open – If a safety switch is open, the control may prevent the gas valve from opening.
6. Fault Condition Detected – The control board may detect an issue and prevent ignition.
Check these components to diagnose and fix the issue.
This answer is automatically generated