Adjust Leveling Legs; Level Range; Install Lower Trim - Whirlpool WDE350LVB02 Installation Instructions Manual

1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the range cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
1. Verify that the anti-tip bracket is installed and engaged by
completing the following steps.
2. If the lower trim is already installed, remove the 2 screws from
the lower trim and set the trim aside. See the illustration in the
"Install Lower Trim" section.
3. Use a flashlight to look underneath the bottom of the range.
4. Visually check that the rear range foot is inserted into the slot
of the anti-tip bracket.
1=
Place rack in oven. Place level on rack and check levelness of
range, first side to side; then front to back.
2. If range is not level, using two or more people remove range
from cutout onto cardboard or hardboard.
3. Use wrench to adjust leveling legs up or down until range is
level. Using 2 or more people, lift range back into cutout.
4. Check that rear leveling leg is engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory baking conditions.
' @J
t
t
/
A
A. Screws
B. Lower trim piece
C, o np ns t
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check that the range is level. See the "Level Range" section.
5. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, read
the "Range Care" section of the Use and Care Guide.
6. Read the "Range Use" section in the range Use and Care
Guide.
7. Slide range into its final location. Check that the flexible
conduit is not bent.
8. Turn power on. Turn on surface cooking elements and oven.
See the Use and Care Guide for specific instruction on range
operation.
If range does not operate, check the following:
• Household fuse is intact and tight; or circuit breaker has not
tripped.
• Electrical supply is connected.
• See the "Troubleshooting" section in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.