Table of Contents
Advertisement
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 8 – Attach Dome to Emitter
• Gently lay Heater on its side using one styrofoam end to prop
up top half.
• Align holes in Dome with threaded studs in Emitter brackets.
• Secure Dome to Emitter using (3) Cap Nuts.
• Leave Heater on its side for next step.
Step 9 – Secure Gas Line
• Make sure angled side of Gas Clip pokes up through large hole in
Platform.
• Tighten screw until Gas Line is held securely in place.
• Stand Heater upright.
At this point it is appropriate to permanently mount your heater to the
surface where you wish to keep it. 3 Holes are provided in the base for
mounting. The means of permanently mounting the heater is up to the
installer, and so no hardware is provided for this proceedure.
Owner's manual and assembly instructions: model 233010 natural gas outdoor patio heater
Note:
The white ceramic cone in the top of
the engine is an important piece. DO
NOT REMOVE.
1/14/03
10
Advertisement
Table of Contents
