Step 6 Connect Gas Line To Engine; Step 7 Assemble Dome - Endless Summer 233010 Owner's Manual

9
Contact 1-800-762-1142 for assistance.
Step 6 – Connect Gas Line to Engine
Step 9 – Assemble dome
Note: Each dome section has a pin mounted in place in the rolled
bottom edge. If necessary for proper alignment of dome sections,
loosen each screw prior to further assembly and retighten after sections
are aligned.
Owner's manual and assembly instructions: model 233010 natural gas outdoor patio heater
Do not return to place of purchase.
• Attach Gas Line to Control Valve:
• Pull collar of Gas Line back.
• Insert Gas Line over Control Valve.
• Release collar and it should lock in place. (Tip – push Gas Line up from
bottom of Post to make a good seating before releasing the collar.)
• Gently tug on line to test for proper connection. If Gas Line moves
you are not properly connected. Do not proceed until you have a
proper connection.
• Fully tighten the (4) screws from Step 4.
• With the large side facing up, slide a dome rib on to the same side
of one dome section as the pin. Slide two dome sections together,
allowing the exposed end of the pin slide into the rolled edge of the
next dome section. Line up hole in dome with threaded hole in pin.
• Insert one Dome Screw and secure loosely.
• Repeat procedure to complete the assembly of all three sections.
• Slide Dome bolt through bottom check plate (with small center
hump), being sure that the rolled edge faces down.
• Slide bolt from previous step through the center of the assembled
dome sections, and be sure that the rolled edge of the check plate
fits inside of the ends of the three Dome Ribs. Also be sure that the
slots in the check plate line up with the holes on the dome sections.
• Slide the other check plate over the Center bolt with the rolled edge
facing up, again making sure that the plate fits inside of the Ribs
and the holes line up with those in the dome.
• Spin the medium nut all the way down the bolt, clamping all of the
pieces in place, making sure that all of the humps fit inside one
another.
• Fully tighten all of the screws in the rolled edge.
• Slide Dome Cap over Dome Bolt, lining up notches in cap with
Dome Ribs. Thread on finial until tight.
1/14/03