Advertisement
Before
you start°°°
Chock
location
where washer/dryer
will be
installed, Proper installation is your
responsibility,
The washer/dryer
must not be
installed
or stored in an area where it will be
exposed
to water
and/or
weather,
Make
sure you have everything
necessary
for
correct
installation,
Location should be large enough to fully
open dryer door 90 °, (See Panel E for
"Recessed and closet installation
instructions" and "Product dimensions,')
Check
utilities: Proper electrical
supply
must be available,
See "Electrical
requirements",
Panel A,
Dryer may be exhausted
from rear or left or right side,
Exhausting
through
the side
requires Side Exhaust Kit Part
No, 279823, See "Exhaust
requirements,"
Panel B,
10.2cm (4 in)
metal exhaust
duct is required.
Standpipe drain system
needs a 5 cm (2 in)
diameter
with a minimum carry-
away capacity of
64,4 litres (14,2 Imperial
gallons) per minute,
Top of standpipe must
be at least 71,1 cm
(28 in) high and no
higher than 121,9 cm
(48 in) from floor,
Floor drain system
requires a siphon
break,
Part No,
285320, available
from your authorized
parts distributor,
SEERECESSED AND CLOSET
INSTALLATION INSTRUCTIONS
ON PANELE.
important
: Observe
all governing
codes
and ordinances.
Check
code requirements.
Some codes
limit
or do not permit the installation
of
washer/dryer
in garages,
closets, mobile
homes and sleeping
quarters,
Contact
your
local building
inspector,
Grounded
electrical
outlet within (1,5m) 5 ft
of the center
rear of cabinet
is required,
See
"Electrical
requirements,"
Panel A,
Drain hose
may also be
installed to a
laundry tub
or floor drain
system,
See Panel D,
Level floor: Maximum
slope under
washer/dryer,
2,5 cm (1 in),
Support: Floor must be sturdy enough
4o support washer/dryer weight with
water and clothes of 170 kg (375 Ib),
Electric
Shock
Hazard
It is the customer's
responsibility:
To contact
a qualified
electrical
installer.
To assure
that the electrical
installation
is
adequate
and in conformance
with
the
Canadian
Electrical
Codes,
and all local
codes
and ordinances.
Failure
to follow
these
instructions
can
result
in death
or electrical
shock.
Hot and cold water faucets must be within
1,2 meters (4 feet) of the back of the
washer/dryer and provide water pressure of
34 to 690 kPa (5-100 psi),
Water heater: Set to deliver
60°C (140°F)
water to the washer,
Laundry tub drain system needs
a 75,7 litres (16,7 Imperial
gallons)
laundry tub, Top of tub
must be at least 71,1 cm (28 in)
high and no higherthan
121,9
cm (48 in) from floor,
If a longer
drain hose is
needed,
Drain Hose Part
No, 388423, and Hose
Connection
Kit Part No, 285442,
are available
from your
authorized
parts distributor,
Do Not store or operate washer/dryer
below
0°C (32°F) (some water may
remain
in washer).
Proper operation
of
dryer cycles
requires temperatures
above
7°C (45°F). See Use & Care Guide for
"Winterizing"
information.
Fire Hazard
For your
safety,
the information
in this
manual
must
be followed
to minimize
the
risk of fire or explosion
or to prevent
property
damage,
personal
injury
or loss
of life.
Do Not use or store
gasoline,
paint,
thinners
and other
flammable
materials
near washer/dryer.
Fumes
from
such
materials
could
result
in fire or explosion.
Never
install
washer/dryer
up against
draperies
or curtains
or on carpet.
To do
so may
result
in a fire.
Keep
any and all items
from
falling
or
collecting
behind
the washer/dryer.
Failure
to do so may result
in a fire.
Replace
all access
panels
before
operating
washer/dryer.
Failure
to follow
these
instructions
may
result
in a fire.
Injury
Hazard
More
than
one person
is required
to lift,
tilt, or move
this
washer/dryer
because
of
its weight
and size.
Failure
to follow
these
instructions
may
result
in injury.
Panel A
TooIs and materiaIs
needed £or
instaIIation:
Phillips
.........
utility knife
screwdriver
safety gEasses
l/4" socket wrench
slip-joint
ornutdriver
pliers that
open
to 3.8 cm
(H/2")
minimum
EIectrica:I
requirements
Electrical
Shock
Hazard
Electrical
ground
is required.
Do Not ground
to a gas pipe.
Improper
connection
of the equipment-
grounding
conductor
can
result
in a risk of
electrical
shock.
Check
with
a qualified
electrician
if you are
not sure
this washer/dryer
is properly
grounded.
Do Not change
the power
supply
cord
plug.
If it will not fit the outlet,
have
a proper
outlet
installed
by a qualified
electrician.
Do Not have
a fuse
in the neutral
or
grounding
circuit.
Do Not use an extension
cord
with
this
washer/dryer.
Failure
to follow
these
instructions
could
result
in death
or electrical
shock.
OBSERVE ALL GOVERNING CODES AND
ORDINANCES
1. A four-wire,
single-phase,
120/240-volt,
60-Hz, AC only electrical
supply is required
on a separate
30-ampere
circuit, fused on
both sides of the line, (Time-delay
fuse or
circuit breaker
is recommended,)
2. This washer/dryer
is equipped
with a four-
wire, 30-amp
rated flexible-type
power
supply cord, It must be plugged
into a
mating
30-amp
receptacle
(NEMA-type
14-30R), See Figure 1,
Use 30-amp
receptacle
where local codes
permit flexible-type
supply cord
(pigtail).
14-30R
4-wire receptacle
Figure 1
Advertisement
