Advertisement
Slide washer/dryer ontocardboardor
hardboardbeforemoving acrossfloor t o
preventdamage tofloor c overing.
hardboard
J
To prevent
product
damage, do
not
remove
corner
posts
before cutting.
With the corner
posts in place,
cut the carton
down one corner,
Remove
carton,
Do Not
remove.
11,
29,
Numbers
correspond
to steps.
1
Remove
the two rear corner
posts located
at the
back of the washer/
dryer, Remove the two
corner pieces
attached
to the lower front of the
washer/dryer,
Do Not
remove
the foam
shipping
pieces
between
the washer
and dryer until the
washer/dryer
is in place,
rear
cornet
posts
O[]
Move foam
latch
shipping
pieces outward
just enough
to clear
the washer lid, Open
the washer lid, The
latch under the dryer will hold lid open,
round
shipping
piece
m Grasp round shipping
piece
at the
front and the back,
Lift to remove
from inside
washer,
[] Take hoses out of basket, Place
hoses with other parts,
Numbers
correspond
to steps.
3
[] Release washer
lid by pushing up on latch,
Close lid,
Use new hoses and washers that came
with your washer/dryer.
4
coupling
washer
[] Insert a flat washer into each end
of the inlet hoses, Check that washers are
firmly seated
in couplings,
Inlet valves are
plastic.
Do Not
strip or
crossthread.
hot
b__
5
[] Attach
hose to bottom
inlet valve opening
first, Attach
second
hose
to top inlet valve, Tighten couplings
by hand;
then use pliers to make an additional
two-
thirds turn,
IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED
TO ASSURE PROPER
INSTALLATION.
__
,
connector
hose
_q,_0.64cm
(114")
max,
0.64cm
(114")
max.
[] To prevent
the drain hose from
coming
off or leaking,
it must be installed
per
the following
instructions:
1, Wet the inside end of the drain hose with
tap water,
DO NOT USE ANY OTHER
LUBRICANT.
2, Squeeze
ears of small clamp
with pliers to
open clamp
and place
clamp
over end
of drain hose,
3, While holding
clamp
open, work end of
drain hose onto drain connector
until
drain hose is within 0,64 cm (1/4 in) of
ribbed
stop,
4, Position clamp
over the drain hose area
marked
"clamp,"
Release clamp,
Clamp
should
be 0,64 cm (1/4 in) from end of
drain hose,
Panel C
Advertisement
