Download Print this page

Table Of Contents; Before Starting Your Washer; Starting Or Stopping Your Washer; Selecting A Load Size - Whirlpool 3401087 Use And Care Manual

Thin twin automatic washer/dryer
Hide thumbs

Advertisement

Operating
Your Washer
In This Section
Page
Page
Before starting your washer . . . . . . . . . . . . . . . . . 7
Selecting a cycle and time . . . . . . . . . . . . . . ,... 8
Using rinse and spin . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Selecting a load size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Using drain and spin . . . . . . . . . . . . . . . . . . . . . . . . . . 10
What happens in each cycle . . . . . . . . . . . . ,. 11
Operating your washer properly ensures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before
starting
your washer
Add measured detergent. Then place a
NOTE:
If your washer/dryer
has a Con-
sorted load in the washer before starting.
sumer Features Guide, remove it and place
See page 20 for additional "Before you wash
it in your Use and Care Guide.
or dry" information.
Starting
or stopping
your washer
Starting your washer:
1.
Select load size and water temperatures.
2. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob's outer ring points to the number in
the wash cycle you want. The numbers
are minutes of wash time.
3. Pull out the Cycle Control Knob.
Refer to pages 8-l 0 for additional informa-
tion to help you make selections.
Stopping and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if
necessary) and pull out the Cycle Control
Knob.
Selecting
a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash. Select a load size based upon the size
of the load and the fabric you are washing.
See pages 20-21 for additional loading
information.
To change the load size setting after the
washer has started to fill, move the Selector
to RESET, then to the desired new setting.

Advertisement

loading

  Related Manuals for Whirlpool 3401087