Table of Contents
Advertisement
Rear Panel
WPS Button
LAN
Reset Button
Power port
Figure 3: Rear Panel
Push the WPS button on the device and on your other wireless device
to perform WPS function that easily creates an encryption-secured
wireless connection automatically.
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub/switch on your LAN.
This button has two (2) functions:
•
Reboot. When pressed and released, the Wireless Access Point
will reboot (restart).
•
Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Hold the Reset Button until the Status (Red) LED blinks TWICE,
usually more than 5 seconds.
2. Release the Reset Button.
The factory default configuration has now been restored, and the
Access Point is ready for use.
Connect the supplied power adapter (12V@1A) here.
Introduction
5
Advertisement
Table of Contents
