Table of Contents
Advertisement
TROUBLESHOOTING
GUIDE
If you have followed
the instructions
contained
in this manual and have diff:,culty in operating your
unit, locate the SYMPTOM in the left column below. Check the corresponding
POSSIBLE CAUSE and
CORRECTIVE ACTION columns to remedy the problem.
SYMPTOM
CORRE,CTIVE ACTION
No power.
•
•
Connect power cord to AC outlet.
•
•
Press PO_
button to ON.
No picture and sound•
•
•
Plug power cord into an active AC outlet.
Sound OK; poor
pictu re.
Picture OK; poor or no
sound.
POSSIBLE CAUSE
Power cord is not connected.
The power is turned OFF.
iV is not plugged into an active ACl
outlet.
Antenna is not connected.
No channel in memory.
Direction
or condition of antenna is
not good.
Picture control is not good.
Interconnecting cable is connected to!
another source.
Volume control on remote control unit
or main unit is in minimum position.
MUTE button on the remote control
unit is in the ON position.
The timer program is set incorrectly.
•
Check ante
connection.
•
Program tur=er's memory.
•
Adjust directio_ or replace antenna•
•
Adjust pictu
_ntrols.
•
Connect incoming antenna directly to the
television.
•
Adjust volu
control on remote control
unit or set.
Press MUT
I:,utton.
Timer recording is not
•
•
Set the tim( I:,rogram correctly.
possible.
•
The power is turned ON•
•
Press POV_
on to OFF.
Record mode cannot be •
The erase-prevention tab on cassette •
Place a pie
of household transparent
engaged,
is missing,
tape over missing erase-prevention
tab
on the tape cassette.
Picture is poor on
•
The TRACKING
control is not set to •
Adjust
TRACKING
control
for
better
playback,
best position,
picture.
Noise in picture on
•
Video heads are dirty.
•
Head clean
g is necessary, consult the
playback,
nearest Sears Service Center.
No operation by
•
No power to TV/VCR.
•
Make sure thq_AC cord is connected to
infrared Remote Control.
an AC outl_
• Weak battery.
•
Check the batteries in infrared Remote
Control•
- 33 -
Advertisement
Table of Contents
