Troubleshooting Guide - Zenith SLV1340S Operating Manual & Warranty

13" color tv/vcr combination,
Table of Contents

Advertisement

TROUBLESHOOTING
GUIDE
If you have followed
the instructions
contained
in this manual
and have difficulty
in operating
your
unit, locate the SYMPTOM
in the left column below. Check the corresponding
POSSIBLE CAUSE and
CORRECTIVE
ACTION columns
to remedy the problem.
SYMPTOM
CORRECTIVE
ACTION
No power.
Connect pcwer cord to AC outlet.
t
Press POWER button to ON.
No picture and sound.
Plug power cord into an active AC outlet.
Check antenna connection.
Program tuner's memory.
Sound OK; poor
Adjust clire(-tion or replace antenna.
picture.
Picture OK; poor or no
sound.
POSSIBLE CAUSE
Power cord is not connected.
The power is turned OFF.
TV is not plugged into an active AC •
outlet.
Antenna is not connected.
No channel in memory.
Direction or condition of antenna is •
not good.
Picture control is not good.
Interconnecting cable is connected to •
another source.
Volume control on remote control unit •
or main unit is in minimum position.
MUTE button on the remote control •
unit is in the ON position.
The timer program is set incorrectly.
Th__e_e
power is turned ON. ______
__.
The erase-prevention tab on cassette I•
is missing.
Adjust picture controls.
Connect in{;oming antenna directly to the
television.
Adjust volume control on remote control
unit or set.
Press MU-[E button.
-i]mer recording is not
Set the timer program correctly.
possible.
Press_PO__WER button !:_o O)--F__:
Record mode cannot be •
Place a piece of household transparent
engaged,
tape over missing erase-prevention
tab
on the tape cassette.
Picture is poor on
The TRACKING
control is not set to •
Adjust
TRACKING
control
for
better
playback,
best position,
picture.
Noise in picture on
Video heads are dirty.
Head cleaning is necessary, consult the
playback,
nearest Sears Service Center.
No operation by
No power to TV/VCR.
Make sure the AC cord is connected to
infrared Remote Control.
an AC outlet.
Weak battery.
Check the batteries in infrared Remote
Control.
- 33 -

Advertisement

Table of Contents
loading

Table of Contents