Wel-Bilt 22481 Owner's Manual page 8

7. Wipe the flange surfaces clean, and install the new wheel, flange and the spindle hex nut.
8. To install a new grinding wheel, reverse the above procedure.
9. Be sure the grinding wheel and outer flange are properly seated on the spindle shaft.
10. Replace the wheel cover and reposition the tool rest.
11. The tool rest, spark deflector and eye shields will need to be readjusted after installation of
the wheel is complete.
12. When turning the grinder on with a newly installed wheel, DO NOT STAND IN FRONT
OF THE GRINDER. Stand to the side and allow the grinder to run for at least one
minute before proceeding to use it.
IMPORTANT! Do not overtighten the spindle hex nut, because this may cause the
wheel to crack.
CAUTION! DO NOT INSTALL OR USE A DAMAGED GRINDING WHEEL. The force of
rotation may cause a damaged wheel to fly apart, and could injure operators or bystanders.
Tool Rest Adjustments and Installation
Mount the tool rests to the work rest bracket using the two hex screws and washers.
Before tightening the bolts, adjust the gap between the grinding wheel and the work rest to a
maximum of 1/8in. Tighten securely.
Adjustments
To prevent the workpiece from being pulled and caught between the tool rest and the wheel,
readjust the tool rest position whenever necessary to maintain the 1/8in. distance.
Page of 14 8