Table of Contents
Advertisement
Installation
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste
( Pro Honda Moly 60 Paste, or equivalent).
1.
Position the wheel between the
swingarm and the final drive gear case.
Be sure the splines on the wheel hub fit
into the final drive gear case.
2.
Install the side collar into the wheel hub.
3.
Install the rear brake bracket, washer
and rear brake bracket bolt.
To avoid damaging the brake pads
while setting the brake caliper
assembly over the brake disc,
carefully fit the brake disc between
the pads.
If You Have a Flat Tire
4.
Insert the rear axle shaft from the left
side, through the left swingarm, rear
brake bracket, wheel hub and final drive
gear case.
5.
Tighten the nut and bolt to the specified
torques:
rear axle nut:
66 lbf·ft (89 N·m , 9.1 kgf·m)
axle holding bolt:
24 lbf·ft (32 N·m , 3.3 kgf·m)
rear brake stopper bolt:
66 lbf·ft (89 N·m , 9.1 kgf·m)
6.
After installing the wheel, apply the
brake several times. Check for free
wheel rotation after the brake is
released. Recheck the wheel if the brake
drags or the wheel does not rotate freely.
Taking Care of the Unexpected
(cont'd)
191
Advertisement
Chapters
Table of Contents
