Honda 2010 NT700V Owner's Manual page 119

Engine Oil & Filter
7. Apply a thin coat of engine oil to the
rubber seal ( ) of a new oil filter. 4
(4)
(4) rubber seal
8. Install the new oil filter and tighten it by
hand.
9. Using an oil filter wrench attachment
and a torque wrench, tighten the new oil
filter to the specified torque:
19 lbf·ft (26 N·m , 2.7 kgf·m)
112
Servicing Your Honda
10. Check the condition of the sealing
washer on the engine oil drain bolt.
Replace the washer every other time the
oil is changed.
Install the engine oil drain bolt and
tighten it to the specified torque:
22 lbf·ft (30 N·m , 3.1 kgf·m)
Add Engine Oil:
11. Fill the crankcase with the
recommended oil (page
approximately:
3.0 US qt (2.8 )
12. Install the oil filler cap/dipstick securely.
105 ),