ELECTRICAL OUTLET LOCATION
Outlet should NOT be in the shaded area as indicated on
If the Depth (C) dimension is greater than 21" (53.3 cm),
the outlet location may be in any area on the rear wall.
The floor of the opening should be constructed of plywood
strong enough to support the weight of the oven and floor
100 pounds). The floor should be level
for proper operation of the oven. Be sure to check the local
building code as it may require that the opening be
enclosed with side, ceiling and rear partition. The proper
functioning of the oven does not require the enclosure.
EXHAUST DUCT ASSEMBLY
Place the Exhaust Duct in the opening. When the
Exhaust Duct Assembly is in the opening correctly,
the flanges will be tightly against the lower edge of
the opening. See Illustration 3.
Secure the Exhaust Duct Assembly with the two
Secure screws in outer hole.