Table of Contents
Advertisement
Washing sequence
Wash selector
(standard current,
strong current)
Wash timer
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
OFF
3
6
9
12
45
15
SOAK
35
25
WASH TIMER
Wash
1. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 1)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the strength of the current according to
the laundries. (Figure 2
4.Select the washing time
Select the washing time according to the
laundries. (Figure 3)
Remarks:
a. 0~15 minute is the normal soaking.
b. 15~45 minute is active soaking. During active soaking,
the pulsator will run for 2 minutes in each 8 minutes. After
the active soaking, it will run normal washing for 15 minutes.
. If you select soaking(i.e. turn the knob to position between
C
15~45 minutes), be sure to
dissolve the washing powder in advance, otherwise the
washing powder may result in damage to the laundries.
5.After washing, the buzzer will ring. Set the "WASH
SELECTOR" at "DRAIN". (Figure4).
8
Spin water-filling entrance
STRONG
STANDARD
DRAIN
WASH
WASH SELECTOR
Spin water-filling entrance
WASH SELECTOR
WASH SELECTOR
Spin timer
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
OFF
5
1
4
2
3
SPIN TIMER
Figure 1
STRONG
STANDARD
DRAIN
Figure 2
OFF
3
6
9
12
WASH
45
15
SOAK
35
25
WASH TIMER
Figure 3
STRONG
STANDARD
Figure 4
DRAIN
Advertisement
Table of Contents
